Quick Start Guide
200-2470 v1
3/16
The IP netmask, gateway and DNS server can be set in the same way. It is important to set the
gateway and DNS server addresses if domain host names are to be used for stream routing.
The MAC address of the unit can be found under the Unit Details/ MAC Address menu, or on the label on
the bottom face of the unit.
If a DHCP allocated IP address is required, navigate the menus to the IP Settings
–
DHCP menu and
press OK to select DHCP. The display will show the allocated IP address details once a lease has been
obtained.
6. Plug the Re-Caster into the LAN switch using the CAT5 patch cable supplied. It will Auto-negotiate up
to a 1000 Mbps link with your network switch. This unit can be used with a 100Mbps network switch,
but it is recommended that the total outbound data rate does not exceed 80Mbps (the network usage
can be found on the Re-
Caster’s Status web page).
7. Connect to the LAN-
Caster’s configuration web pages using a PC
/MAC and Web browser software
(e.g. Edge, Chrome or Firefox), by entering the Re-
Caster’s IP address into the browser’s address bar.
Click through any warnings and the Re-
Caster’s specification page will then be shown.
8. Click on the Date/Time page link on the left-hand side panel and set up an NTP time server. If no
local time server is available, the internet based pool.ntp.org server is recommended. Ensure the Re-
Caster’s network settings have been configured to allow it access to the internet.
9. Click on the Routing page link on the left-hand side panel and configure the Re-Caster for use. There
is no limit to the number of simultaneous Routes that can be configured; however, users should ensure
the CPU Memory and Network usage indicators on the status page do not go far above 80% in use. This
provides a margin to allow for any transient peak conditions. If the capacity of the Re-Caster is
exceeded, TV picture disruption may occur.
The status page usage indicators keep the peak readings previously seen. These peaks can be reset on
the Enablement web page by clicking the appropriate check box followed by Apply.
