Quick Start Guide
200-2470 v1
6/16
3.
Click on the padlock symbol at the right-hand end of the Source field. Enter the same passphrase
that the stream is being encrypted with at site A.
4.
Check the Enable Destination checkbox. Select the UDP:// setting on the Destination field drop-
down and enter the multicast stream address and port number that the Re-Caster will use to
stream the IP video stream onto the LAN.
If the Re-Caster needs to stream the same IP TV channel source to another multicast or unicast
address or other SRT linked site, click on the Enable checkbox on the Destination field below and
add more destination addresses.
5.
Set the TTL and DSCP settings for the multicast stream.
6.
Enter the logical name for the route in the Route name field (Channel 1 shown here) and then
Apply the settings.
7.
As before, after a few seconds the incoming and outgoing stream data rates will be shown so you
can see the SRT connection has been made and the outgoing stream is making its way onto the
LAN.
If the SRT connection cannot be established with the remote site, then an error message will be
shown on the Route entry. In this case, check the IP address of Site B has been set correctly on
the Site A Re-Caster as a valid stream destination and check a valid internet network gateway has
been configured on this Re-Caster. Also disable (+Apply) and re-enable (+Apply) the SRT
connection to Site A on this Re-Caster to reset the connection.
To allow Site B to transmit a live IP TV channel to Site C, add a new multicast to SRT route in the Site B
Re-Caster and an SRT to multicast route in the Site C Re-Caster.
