Quick Start Guide
200-2470 v1
9/16
4.
Check the Enable Destination checkbox. Select the UDP:// setting on the Destination field drop-
down and enter the multicast stream address and port number that the Re-Caster will use to
stream the IP video stream onto the LAN.
If the Re-Caster needs to stream the same IP TV channel source to another multicast or unicast
address or other SRT linked site, click on the Enable checkbox on the Destination field below and
add more destination addresses.
5.
Set the TTL and DSCP settings for the multicast stream.
6.
Enter the logical name for the route in the Route name field (Channel 1 shown here) and then
Apply the settings.
7.
After a few seconds check that an incoming data rate is shown (near the bottom of the Route
entry right-pointing arrow). This indicates the Re-Caster is successfully accessing the incoming IP
TV stream. If this remains at zero, check the correct IP address of the
device
providing the
stream has been set (click on the Source field, list box symbol), and check the receiving port
number set here is the same as that set in the Destination field of the site A Re-Caster.
The outgoing data rate (left pointing arrow) will reflect the total outgoing data rate of that TV
channel.
