671-2001 601 Quick Start Guide_V1e.docx Page 4 of 5
Issue 1
Weight:
0.2Kg / 0.45Ib
Ambient Operating temperature:
0 - 40°C / 32 - 104°F
Power Supply:
LPS 100-240VAC, 50/60Hz Output: +5VDC 2 Amps, with a DC jack plug (centre positive voltage, 3.5/1.35
mm diameter x 9 mm long)
Power dissipation:
10W max
Approvals:
FCC part 15.247, 15.207, 15.209
RSS-247
TUV, CB
United States of America
This product does not contain any user serviceable parts. No changes shall be made to the equipment as
this may void the electromagnetic compatibility (EMC) and wireless compliance and negate
the user’s
authority to operate this equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20 cm (8
”
) between the unit and
your body. This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures: • Reorient or relocate the receiving antenna. • Increase the separation between the
equipment and receiver. • Connect the equipment into an outlet on a circuit differ
ent from that to
which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help
.
FCCID: 2APSA6011000
