USER’S GUIDE
200 CyberSWITCH
The following table identifies the configuration requirements for possible security options for
remote bridge devices.
*Conditionally Required means you must specify at least one of either the Calling Line Id or the
Ethernet Address. You may specify both.
IP Routing with HDLC Bridge Devices
To allow devices to connect to the CyberSWITCH using IP routing through a Bridge device, you
must configure a RLAN Interface. IP routing must also be enabled. For each HDLC Bridge using
this type of connection, you may need to enter the Device Name, Calling Line Id, Remote Bridge
Ethernet Address, Bridge Password, and IP (Sub) Network Number.
The following table identifies the configuration requirements for possible security options for IP
Routing with Bridge Devices.
*Conditionally Required means you must specify at least one of either the Calling Line Id or the
Ethernet Address. You may specify both.
Security Mode Configuration
On-node Device Table Configuration Data
Calling Line Id Bridge Ethernet
Address
Calling Line Id
Bridge Ethernet
Address
Bridge Password
Enabled
Disabled
Required
Not
Requested
Not Requested
Disabled
Enabled
Not Requested
Required
Optional per
device entry
Enabled
Enabled
Conditionally
Required*
Conditionally
Required*
Optional per
device entry
(if entry specifies
an Ethernet
Address)
Security Mode
Configuration
On-node Device Table Configuration Data
Calling
Line Id
Bridge
Ethernet
Address
Calling Line Id
Bridge
Ethernet
Address
Bridge Password
IP (Sub) Network
Number
Enabled
Disabled
Required
Not
Requested
Not Requested
Required if only IP
Routing is Enabled
Disabled
Enabled
Not
Requested
Required
Optional per
device entry
Required if only IP
Routing is Enabled
Enabled
Enabled Conditionally
Required*
Conditionally
Required*
Optional per
device entry
(if entry
specifies an
Ethernet
Address)
Required if only IP
Routing is Enabled
