Central Site Remote Access Switch 425
V
ERIFYING
THE
B
ASE
S
YSTEM
Remote Device Connectivity
fix> ConnId=<connect Id>
In - CONNECT Call Id=<call Id> Slot=<slot#> Port=<port #>
Chans=<bearer channel map> Ces=<communication endpoint suf-
fix> ConnId=<connect Id>
If the system reports these messages, then continue with the next step.
If the system does NOT report these messages, the remote device is not correctly connect-
ing to the system. Check and verify the configuration of the remote device.
4.
If the system displays the following message among the system messages:
Security Rejection-Invalid Calling Line Id - <#>
the network is indicating a calling line identifier that is not configured for any valid device in
the system Device list. The number “# ” indicates the actual number presented by the network.
5.
For Remote Bridge Devices:
If the system displays the following messages among the system messages:
Security Rejection - Caller did not negotiate security
Security Rejection - No Bridge Address given by caller
Security Rejection - Unknown Calling Bridge
Security Rejection - No Password given by caller
Security Rejection - Invalid Password given
Security Rejection - HDLC not supported by the caller
review the system configuration for the Device List. You can also refer to the
System Messages
chapter for the message meanings and the appropriate actions to be taken.
6.
For IP Host Devices:
If the system displays the following messages among the system messages:
IP Call Dropped: ID_RSP was not received from remote
IP Call Dropped: XID was not received from remote
IP Security Rejection - Digit string wrong length
IP Security Rejection - Invalid Security ID <Id string>
Review the system configuration for the Device List. You can also refer to the
System Messages
chapter for the message meanings and the appropriate actions to be taken. The first two
messages indicate that the system did not receive the required protocol data. The second two
messages indicate that the security configuration is incorrect.
7.
For PPP Devices:
If the system displays any error or warning messages that begin with the following prefixes:
[PAP].....
[CHAP].....
[AUTH].....
There probably is an error in the remote device configuration. Review your remote device
configuration. You can also refer to the
System Messages
chapter for the message meanings and
the appropriate actions to be taken.
