V
ERIFYING
R
OUTING
P
ROTOCOLS
O
VERVIEW
This chapter describes the verification process for the following CyberSWITCH routing protocols:
•
IP Routing
•
IPX Routing
•
AppleTalk Routing
To perform the verification procedures, WAN lines must be available and ready to use. LAN
attachment components must also be available and ready to use.
During some of the procedures, we ask you to enter an administration console command. To enter
these commands, you must have an active administration session. If you need instructions for
starting an administration session, refer to
Accessing the CyberSWITCH
.
Accessing the CyberSWITCH
.
Note:
At least one remote device is required to proceed with many of the verification procedures.
IP R
OUTING
O
PERATIONAL
?
IP R
OUTING
O
VER
A
LAN I
NTERFACE
To verify that IP routing is operating properly over the LAN connection, an IP host must be
connected to the local LAN port on the CyberSWITCH. The host must be properly configured and
operational on the IP network to which it is connected.
Below is an example of a configuration used to verify IP routing over a LAN connection. It uses IP
addresses specific to the example. Substitute the IP addresses of your network when you perform
the IP routing verification steps.
1.
Determine if the CyberSWITCH can access the local IP host. On the administration console
type:
ip ping 100.0.0.2
<return>
Host A
100.0.0.1
100.0.0.0
100.0.0.2
CSX5500
