USER’S GUIDE
498 CyberSWITCH
DM card failed FLASH download bad xx SREC
The Digital Modem card has failed the firmware update due to a corrupt file. Contact your
Distributor or Customer Support.
DM card in slot <slot # > has bad FLASH
The FLASH memory on the Digital Modem card has been identified as bad during an attempt to
update or access it. Contact your Distributor or Customer Support.
DM card in slot <slot # > in unknown state
The Digital Modem card is in an unrecognizable state. Reseat the card in its ISA slot, and/or check
the MVIP cabling. If the problem persists, contact your Distributor or Customer Support.
DM card in slot <slot # > is not functional
The system was unable to initialize the Digital Modem in the specified slot correctly. Check all
switch and/or jumper settings on the board to ensure they match the values in CFGEDIT. If the
board is configured properly, and this message still appears, contact your Distributor or Customer
Support.
DM card in slot <slot # > will receive new firmware
Informational message stating that the system has detected that the current firmware of the
specified modem is a lower revision level than what is supported in the currently installed
software. For 56K modem technology, the system will attempt to update the card. For modem
technology other than 56K, the upgrade command must be used to upgrade the firmware revision.
Watch for subsequent log messages to ensure the update is successful.
DM card in slot <slot # > failed FLASH download
The system has failed to successfully update the firmware revision of the Digital Modem card.
Contact your Distributor or Customer Support.
DM card in slot <slot # > FLASH download complete
Informational message stating that the system has successfully updated the firmware present on
the Digital Modem card.
DM card in slot <slot # > is initializing
Informational message when digital modem card first powers up; card in process of initializing.
DM card in slot <slot # > is not usable, could not upgrade
The modem firmware upgrade process failed for this card. Call your Distributor or Customer
Support.
DM card in slot <slot # > is reinitializing
This message may display after the system attempts a Digital Modem initialization on power up.
If the system determines the Digital Modem card needs new firmware, or if the Digital Modem did
not initialize correctly, it will try again. Watch for subsequent log messages to determine if a course
of action is necessary.
DM card in slot <slot # > signals it is operational
Informational message stating that the Digital Modem is now ready for use.
DM card type configured in slot <slot # > does not exist
Using the resource database, the system has tried to initialize a Digital Modem card that doesn’t
exist. Check all switch and/or jumper settings on the board to ensure they match the values in
