Central Site Remote Access Switch 509
S
YSTEM
M
ESSAGES
System Message Summary
[IP] Cannot process incoming remote IP device <IP address>, no rsc avail
The IP software was unable to accept the incoming IP device to a WAN (Direct Host) interface
because it could not obtain necessary resource. The WAN connection may remain for a while, but
the remote IP device will not be able to communicate with any IP devices over WAN. Contact your
Distributor or Customer Support.
[IP] Cannot start Proxy Arp for <IP address # >, no cmd buf avail
The IP software attempted to start the proxy arp for the IP device indicated by the <IP address # >,
but was unsuccessful because it could not obtain necessary memory. Contact your Distributor or
Customer Support.
[IP] Cannot stop Proxy Arp for <IP address # >, no cmd buf avail
The IP software attempted to stop the proxy arp for the IP device indicated by the <IP address # >,
but was unsuccessful because it could not obtain necessary memory. Contact your Distributor or
Customer Support.
[IP] Datagram with destination address of <destination address> cannot be forwarded
[IP] Reason: Invalid Device Info. Device <device name> is not IP callable
These two message appear together if a user calls in to the specified destination user and that user
is not configured to be IP callable.
[IP] Default Route not added, invalid next hop (<IP address # >)
Because of an incorrect setup, the default route entry was not added in the routing table. Check the
next hop in your configuration. Be sure that the next hop indicated by the <IP address # > is directly
connected to the configured network interface.
[IP] Failed to de-register with IP Address Pool Manager (erc=x)
A failure was encountered by the IP subsystem during initialization processing. IP made an
unsuccessful attempt to de-register as a provider of “static” addresses for the IP address pool.
Contact your Distributor or Customer Support.
[IP] Failed to register with IP Address Pool Manager (erc=x)
A failure was encountered by the IP subsystem during initialization processing. IP made an
unsuccessful attempt to register as a provider of “static” addresses for the IP address pool. Contact
your Distributor or Customer Support.
[IP] Initialization failure
The IP Router was not initialized correctly because of other errors. Possible errors include “[IP]
Cannot get system memory for xxxx”. Refer to the log for additional messages to pinpoint the
problem.
[IP] Invalid configuration for Network Interface dd
IP routing is not properly configured. Refer to the
IP Network Interfaces
section to verify.
[IP] Invalid RLAN IP Address <IP address>, RLAN IP Stream Closed
The connection from a HDLC Bridge or a PPP device came up and the IP (sub-) network number
configured for it is invalid; it does not belong to any of the WAN (RLAN) interfaces. Correct the IP
address for the remote device.
