Central Site Remote Access Switch 521
S
YSTEM
M
ESSAGES
System Message Summary
No Sites Connected
Currently, no sites are connected to the system.
Not enough memory for Security module
Not enough system memory available to operate security module. Contact your Distributor or
Customer Support.
No UA seen in response to SABMEs - Slot=<slot # > Port=<port # > Ces=<communication endpoint suffix>
Layer 2 cannot be established between the system and the switch. This could be a TEI configuration
mismatch between the system and the switch for the indicated line. Check the configuration of the
system. If this is not the problem, call your carrier. The configuration of the switch may need
correction, or the line may need to be manually restarted.
No VCB buffer available
Ran out of sending buffers for messages to Combinet. If this is a recurring problem, contact your
Distributor or Customer Support.
Number of optional connections reduced from xx to yy due to memory limitations
This informational message identifies that there is not enough memory available to accommodate
the system’s total capacity load for optional connections.
Number of required connections reduced from xx to yy due to memory limitations
This informational message identifies that there is not enough memory available to accommodate
the system’s total capacity load for required connections.
Offnode server lookup of Dial Out User failed.
Off-node authentication was not successful. Most likely, the device attempting to authenticate was
not configured. Check configuration.
OSW <OSWFileName>, found in the Flash File System. The OSW has not been updated from this file due
to insufficient Flash File System space. Please delete unnecessary files from the system.
Delete unneeded files to free up Flash File System space, and reboot the system. DO NOT DELETE
NEX.BIN, IOP.BIN, OR UPGRADE.BIN. The system will again attempt to install the compressed
file set after the system is rebooted again.
Outgoing calls barred - Slot=<slot # > Port=<port # >
The system cannot place outgoing calls on the indicated line. The switch must be configured to
handle circuit switched data calls. Contact your phone company and report the problem.
Out of accounting records
Contact your Distributor or Customer Support.
Out of CCBs, Port=<port # >, CallRef=<call reference # >
Contact your Distributor or Customer Support.
Out of LAN Adapter transmit command descriptors
The LAN adapter is temporarily out of buffers used to transmit frames on to the Ethernet. This
condition should clear. If it persists, contact your Distributor or Customer Support.
Out of overflow RAM buffers
Contact your Distributor or Customer Support.
