Central Site Remote Access Switch 549
T
RACE
M
ESSAGES
Call Trace Messages
In - PROGRESS Call Id=<call Id> Slot=<slot # > Port=<port # > Chans=<bearer channel map>
CauseLoc=<cause location> Cause=<cause value> Signal=<signal value> ProgLoc=<progress location>
Prog=<progress value> Ces=<communication endpoint suffix> ConnId=<connect Id>
The system has received a call progress message from the network. This is usually received in
response to sending a call request. The <parameters> are included for your Distributor or
Cabletron Customer Support.
Refer to the Cause Codes Table for more information.
In - REJECTION Call Id=<call Id> Slot=<slot # > Port=<port # > Loc=<location> Cause=<cause value>
Ces=<communication endpoint suffix> ConnId=<connect Id>
The system has received a call rejection message from the network. This is in response to sending
a call request. The Call Id and Ces values are included for your Distributor or Cabletron Customer
Support. The remaining parameters are used to report line details.
Refer to the Cause Codes Table for
more information.
Interworking unspecified cause
Informational call trace message. This message is used to indicate additional details on the <cause
value> received in the call progress information message.
Refer to the Cause Codes Table for more
information.
Off-hook warning tone on
Informational call trace message.
Origination call address is non-ISDN
Informational call trace message.
Out - ALERTING Call Id=<call Id> Slot=<slot # > Port=<port # > Chans=<bearer channel map>
The system is sending a connection to the network. This is sent in response to receiving a call
indication. The <parameters> are included for your Distributor or Cabletron Customer Support.
Out - BRD CFG Slot=<slot # >
The system is initializing the indicated adapter.
Out - CALL RQST ACK Call Id=<call Id> Rate=<data rate> Slot=<slot # > Port=<port # > Chans=<bearer
channel map> TN=<telephone number dialed> Ces=<communication endpoint suffix> ConnId=<connect
Id>
The system is sending a call request to the network. The Call Id and Ces values are included for
your Distributor or Cabletron Customer Support. The remaining parameters are used to report line
details.
Out - configure <port # >
The system is initializing the indicated line adapter.
Out - CONNECT Call Id=<call Id> Slot=<slot # > Port=<port # > Chans=<bearer channel map>
Ces=<communication endpoint suffix> ConnId=<connect Id>
The system is sending a connection to the network. This is sent in response to receiving a call
indication. The <parameters> are included for your Distributor or Cabletron Customer Support.
Out - DISCONNECT Call Id=<call Id> Slot=<slot # > Port=<port # > Cause=<cause value>
Ces=<communication endpoint suffix> ConnId=<connect Id>
The system is sending a disconnect to the network to terminate a call. The Call Id and Ces values
are included for your Distributor or Cabletron Customer Support. The remaining parameters are
used to report line details.
Refer to the Cause Codes Table for more information.
