USER’S GUIDE
596 CyberSWITCH
Unable to prompt for device name at this time
Indicates that the
call
command would prompt you for a device name, but the necessary
resources are not available. The recommended actions are as follows:
1.
If possible, enter the device name on the command line.
2.
If the device name cannot be entered from the command line (for example, the device
name contains command line delimiters of a space, a comma, a colon, or a tab), the
device can wait for a few minutes and see if any resources become available.
3.
If actions 1 and 2 are ineffective, this may indicate an internal problem in the System,
please inform your service representative of the occurrence.
C
ALL
D
ETAIL
R
ECORDING
C
OMMANDS
The following commands are used to monitor and verify the call detail recording (CDR) feature.
cdr stats
Display the CDR statistics. Refer to
Call Detail Recording Statistics
, for the available statistics and
corresponding definitions.
cdr stats clear
Clears the CDR statistics; setting them all to zero.
cdr verify
Generates a “verify” report to all servers that have been configured for CDR use, then typically
displays a list of all servers to which it sent the messages. If no log servers or events are
configured for CDR, it will report that no messages were sent.
Refer to
Log Commands
for the commands that will allow you to display or erase CDR log reports.
C
ALL
R
ESTRICTION
C
OMMANDS
When the Call Restriction feature is enabled on the CyberSWITCH, the following command is
available through the administration console:
cr stats
Displays the current Call Restriction statistics. Refer to
Call Restriction Statistics
, for a list of
available statistics and their definitions.
Other Call Restriction commands are available through Dynamic Management. Refer to
Configuring Call Control
for these commands.
