QUICK START
14 CyberSWITCH
devices (PPP devices), simply delete these two devices. At the manage mode prompt, enter the
following command:
device delete
Follow the on-screen instructions for deleting each device.
To change the preconfigured devices’ names and secrets to secure the access to the system,
enter the following command at the manage mode prompt:
device change
Follow the prompts to change the device name and secret for User1 and User2. After you have
either deleted or changed the device information, make these changes permanent by entering
the
commit
command
2.
Disable TFTP Server.
Disable through Dynamic Management’s manage mode. This will secure important device
information. Device information must be secure to prevent unauthorized access to the
CyberSWITCH. To disable this access, enter the following command at the manage mode
prompt:
tftp change
Then follow the on-screen instructions to disable the TFTP feature.
3.
Change the admin and guest system passwords.
If your system was previously accessed by your distributor, the preconfigured password will
be admin (in lower case). Change this password to secure your system. To make this change,
enter the following command at the system prompt:
pswd
Then follow the prompts to enter a new password. Your password must be a 3 to 16 nonblank
character string. Be careful, passwords are uppercase and lowercase sensitive.
I
NITIAL
I
NSTALLATION
S
TEPS
There are initial configuration steps you must complete (regardless of remote device connections).
We outline these steps in the following sections.
B
EGINNING
THE
C
ONFIGURATION
P
ROCESS
1.
When you power on your system, the CyberSWITCH program automatically starts. Enter your
log-in id (
admin
)
. Next, enter a password.
2.
Start up the configuration editor, CFGEDIT; at the system prompt, type:
cfgedit
Note:
If you are unsure of any configuration values, use the defaults.
Use the displayed CFGEDIT menu to complete the remaining configuration steps.
