Central Site Remote Access Switch 21
C
ONNECTIVITY
Connecting a Central Site Product to a Workgroup Product via PPP
•
enable IPXWAN protocol
•
select Triggered RIP/SAP with a WAN peer type of ACTIVE from the Routing Protocol
option
Note:
By using triggered RIP/SAP, you do not need to configure static routes or services.
C
ONFIGURATION
FOR
S
ITE
"R
EMOTE
"
The configuration on Remote to allow IPX Routing to Central using PPP is as follows:
1.
Perform
initial configuration
steps.
2.
Under Options, select IPX Routing, then:
a.
Enable IPX Routing.
b.
Under IPX Internal Network Number enter the following value: 456789.
c.
Under IPX Interfaces add a LAN Interface and a hexadecimal IPX Network Number
(33333333).
3.
Under Security, select System Options and Information, then under System Information:
a.
Set your System Name (Remote). This matches up with Remote device information
configured on Central.
b.
Set your System Secret (Remote_S). This matches up with Remote device information
configured on Central.
4.
Under Security, select Device Level Databases, select On-node Device Entries, then add a device
where the Device Name (Central) must match the system name on Central. When you add the
device you must then enter the following information:
a.
Under ISDN Information select ISDN Line Protocol then select PPP.
b.
Under ISDN Information you must enter a dial out number (13135551111) and a base data
rate (64Kb) to dial out to Central.
c.
Under Authentication you must:
•
Change CHAP Secret so that it matches Central’s System secret (Central_S).
•
Optional: Configure Calling Line Ids (if Calling Line Id security was enabled).
d. Under IPX Information:
•
enable IPX
•
enable Make Calls for IPX data
•
enable IPXWAN protocol
•
select Triggered RIP/SAP with a WAN peer type of ACTIVE from the Routing Protocol
option.
Note:
By using triggered RIP/SAP, you do not need to configure static routes or services.
