QUICK START
26 CyberSWITCH
c.
Define Central’s phone settings. Enter 13135551111.
d. Optional: Define Caller ID Numbers if Caller ID Security was enabled. Click Next.
e.
Configure a default route to Central. Click Default Route.
f.
Enable Network Address Translation. Click Advanced, and then Yes. Enable Network
Address Translation by clicking in the box. Click Next.
4.
Click Save.
IPX R
OUTER
TO
IPX R
OUTER
C
ONFIGURATION
If your network protocol is IPX and you want the central site to be able to call the remote site, than
you should route between the central site and the CSX100. If you have a server on the CSX100 side
you will also need to route.
C
ONFIGURATION
FOR
S
ITE
“C
ENTRAL
”
The configuration on Central to allow IPX Routing to Remote using PPP is as follows:
1.
Perform
initial configuration
steps.
2.
Under Options, select IPX Routing, then:
a.
Enable IPX Routing.
b.
Under IPX Internal Network Number enter the following value: 123456.
c.
Under IPX Interfaces add a LAN Interface and a hexadecimal IPX Network Number
(0000BABE).
3.
Under Security, select System Options and Information, then under System Information:
a.
Set your System Name (Central). This matches up with Central device information
configured on Remote.
b.
Set your System Secret (Central_S). This matches up with Central device information
configured on Remote.
ISDN
Network #0000BABE
Network # 0000FACE
FILESER1
Node # 0409A0111111
IN # 432109*
CSX5500
Phone # 13135551111
IN # 123456*
CSX100
Phone # 13135552222
* IN # = Internal Network Number
"Central"
"Remote"
C A B L E T R O N S Y S T E M S
