Chapter 7: AT Commands and Registers
7-42
CSMIM-T1 Hardware Installation Guide
:Tn?
Where n is an integer from 0 to 29, indicating a :T register.
Displays the contents in decimal form only of register “n”.
Register Descriptions
S0=n
Ring to Auto-Answer On
Range:
0 - 255 rings
Default:
1 ring (auto-answer enabled)
Sets the number of rings required before the modem answers.
ATS0=0 disables auto-answer.
The modem ignores ring signals for 5 seconds after disconnect.
S1=
n
Ring Counter
Range:
0 - 255 rings
Default:
0 rings
Keeps a running total of the number of rings that occur before
the modem answers a call. If no ring occurs within 8 seconds
after the last ring, the ring counter resets to 0.
The modem ignores ring signals for 5 seconds after disconnect.
S2=
n
Escape Code Character
Range:
0 - 255, ASCII decimal
Default:
43 (+)
Sets the character used for the three-character escape code
sequence. When the modem is in connect state and receives the
escape code sequence, it enters command state. Setting register
S2 to 0 disables the escape code character. See register S12 to
set the guard time that brackets the escape code character.
The modem does not store this register with &W; enter *W to save it.
S3=
n
Carriage Return Character
Range:
0 - 127, ASCII decimal
Default:
13 (carriage return)
Sets the character recognized as a carriage return. The carriage
return terminates command lines and result codes.
The modem does not store this register with &W; enter *W to save it.
Summary of Contents for CSMIM-T1
