C
ONNECTIVITY
O
VERVIEW
The Small Office CyberSWITCH can communicate with various other CyberSWITCH products via
a PPP connection. This connection can be used to transmit data and provide remote management
of your remote systems with Telnet, TFTP and SNMP. We will describe how to set up a PPP
connection with other CyberSWITCH systems. For these examples, we are assuming that
CyberSWITCH “Remote” is the remote system, and will want to call into CyberSWITCH “Central”;
Central may or may not want to call Remote.
C
ONNECTING
O
NE
C
ABLETRON
P
RODUCT
TO
ANOTHER
VIA
PPP
In this section, we describe the configuration steps required for connecting two of our products
together via PPP. Separate instructions are included for
bridging
,
IP routing with an UnNumbered
Interface
,
IPX routing
, and
AppleTalk routing
configurations.
B
RIDGE
TO
B
RIDGE
C
ONFIGURATION
Configuration for Site "Central"
The configuration on Central to allow Bridging to Remote using PPP is as follows:
1.
Perform
initial configuration
steps.
2.
Select Options from the main menu.
3.
Select Bridging from the options menu, then ensure that bridging is enabled.
4.
Select IP Routing from the options menu, then disable IP routing to allow timely bridging of IP
data.
ISDN
Server
CSX1200
CSX150
Phone 13135551111
Phone 13135552222
POWER
SERVICE
TX
RX
10BASE - T
LAN B-CHANNELS E1 ONLY
B2 B4
B6 B8
B26 B28
B22 B24
B18 B20
B14 B16
B10 B12
B30 L1
B1 B3
B5 B7
B25 B27
B21 B23
B17 B19
B13 B15
B9 B11
B29 B31
E1
D
T1
D
"Central"
"Remote"