Small Office Remote Access Switch 67
C
ONFIGURATION
T
OOLS
Default Configuration
D
EFAULT
C
ONFIGURATION
Your CyberSWITCH is shipped with a default set of configuration files that are preinstalled. These
configuration files provide basic functions which will allow you to perform initial installation tests
with no additional configuration.
The default configuration files will allow IP access over both the LAN and the WAN interfaces. This
will allow you to PING, TELNET and TFTP into the CyberSWITCH. For example, these defaults
will allow you to TELNET into the system and log in. Once logged in, you may execute any of the
console commands available.
Once you perform initial testing, you must set the proper IP addresses. Most of these defaults will
be country-independent. As with any set of defaults, there may be specific cases where these are
not correct and must be changed before the units are connected to the networks.
Default Configuration Summary:
•
Bridging Disabled
•
IP Routing Enabled
•
IP LAN Interface with IP address 1.1.1.1
•
Device Level Security
•
CHAP enabled
•
USER1 configured as PPP device (USER1 as secret) UnNumbered IP
•
USER2 configured as PPP device (USER2 as secret) IP address 002.002.002.003
•
Single BRI line and resource configured on country-specific basis:
JAPAN:
Point-Multipoint Automatic TEI
Switch type: NTT INS
EUROPE:
Point-Multipoint Automatic TEI
Switch type: NET3
(default country code: Norway)
U.S.:
Point-to-point lines
BRI_5ESS
•
Single data link (with no SPID) configured
•
IP WAN Interface with IP address 2.2.2.2
•
TELNET and TFTP enabled
•
TFTP allows all files to be changed by ADMIN
U
SING
THE
N
ETWORK
W
ORKSHEETS
Please take the time to fill out the requirements worksheets located in
System Worksheets
. The
requirements worksheets are:
•
Network Topology Worksheet
•
System Details Worksheet
•
System Device List Worksheet(s)
•
Bridging/Routing Worksheets
These worksheets will be helpful in configuring and managing your system. They capture
important network information. To see examples of completed worksheets, refer to the Example
Networks Guide.
