General Configuration Screen
DLEHF-MA User’s Guide
5-53
5.15.12 Clearing NVRAM
Clearing NVRAM allows the user to clear all user-entered parameters, such
as IP address and Community Names, from NVRAM.
Clear NVRAM as follows:
1.
Use the arrow keys to highlight the Clear NVRAM field.
2.
Use the SPACE bar to toggle the field to YES.
3.
Use the arrow keys to highlight SAVE at the bottom of the screen.
4.
Press ENTER. The warning shown in Figure 5-19 displays.
5.
Use the arrow keys to highlight YES and press ENTER. The message
“CLEARING NVRAM. REBOOT IN PROGRESS...” displays.
The DLEHF-MA clears NVRAM and reboots. All user-entered
parameters default to factory settings.
Figure 5-19
Clear NVRAM Warning Screen
!
Clearing NVRAM will result in the loss of all user-entered
parameters. Do not proceed unless you completely understand
this procedure.
WARNING
236226
YOU HAVE ELECTED TO CLEAR NVRAM. THIS WILL CLEAR
ALL SYSTEM DEFAULTS INCLUDING BUT NOT LIMITED TO
IP ADDRESS, INTERFACE CONFIGURATION, AND COM PORT
CONFIGURATION, THEN REBOOT THIS MODULE.
ARE YOU SURE YOU WANT TO CLEAR NVRAM?
YES
NO
