Installing the DLEHF-MA Into the DLM6C-AA Chassis
DLEHF-MA User’s Guide
3-3
4.
Remove the module from the plastic bag. (Save the bag in the event
the module must be reshipped.)
5.
Examine the module for damage. If any damage exists, DO NOT
install the module. Immediately contact your DIGITAL
representative.
6.
Locate the slot guides that line up with the number of the slot in which
the module will be installed. Install the module in the chassis by
aligning the module circuit card between the upper and lower metal
rail guides of the desired slot, sliding it into the chassis, and locking
down the top and bottom plastic locking tabs, as shown in Figure 3-1.
!
To prevent damaging the backplane connectors in the following
step, take care that the module slides in straight and properly
engages the backplane connectors.
In the following step, ensure that the top plastic locking tab
lines up with the desired slot number located on the front panel
of the chassis. Refer to Figure 3-1.
