2-14
Unpacking and Installing Your ELS10-26
2. Insert one end of the SC connector into the FE-100FX installed
in the ELS10-26. See Figure 2-8.
3. At the other end of the fiber optic cable, attach the SC
connector to the other device.
Figure 2-8. FE-100FX Port
4. Verify that a Link exists by checking that the port LINK LED is
solid green. If the LINK LED is off, perform the following
steps until it is on:
a. Check that the power is turned on for the device at the
other end of the Link.
Caution:
Do not touch the ends of the fiber optic strands, and do not let
the ends come in contact with dust, dirt, or other contaminants.
Contamination of the ends causes problems in data
transmissions. If the ends become contaminated, clean them
with alcohol using a soft, clean, lint-free cloth.
FE-100
FX
16
RX LED
Summary of Contents for ELS10-26TX
