Configuring Your ELS10-26
3-5
To change the subnet mask, at the LCM prompt:
1. Type
ipaddr <PORT-NUMBER> <IP ADDRESS> <SUBNET MASK>
For example,
ipaddr 6 192.138.217.40 255.255.240.0
would set
the subnet mask for port 6 to 255.255.240.0. LCM responds by
redisplaying the current address table.
3.2 ENABLING BRIDGING
The LCM
bridge
command allows you to set bridging options for a
single port or a range of ports. The options include:
• off
• on (the default with
BPDU
enabled)
• no
BPDU
BPDU (Bridge Protocol Data Unit) is a data unit transmitted as part
of the IEEE 802.1d Spanning Tree protocol. The exchange of BPDUs
allows bridges within a network to logically configure the network
as a single spanning tree.
Note:
When you change the subnet mask for a port, you must also enter
the IP address for that port. Make sure you enter the IP address for
the port correctly; whatever you enter becomes the IP address for
that port.
Note:
Selecting the
noBPDU
option could make your network inoperable
because the ELS10-26 would be unable to detect loops.
Summary of Contents for ELS10-26TX
