Configuring Your ELS10-26
3-17
The LCM commands used to create the previous configuration are
as follows:
1. To create workgroup A on ports 3, 4, 5, 13, and 16:
ESL10-26 > workgroup A 3-5,13,16
LCM responds with the following display:
Name: a
Ports: 3, 4, 5, 13, 16
Info: all
2. To create workgroup B on ports 7, 11, 16, and 24:
ESL10-26 > workgroup B 7,11,16,24
LCM responds with the following display:
Name: b
Ports: 7, 11, 16, 24
Info: all
Port 16 has been assigned to a segment that includes ports that
belong to workgroup A and workgroup B. Port 13 connects
workgroup A to the router and port 24 connects workgroup B to
the router.
In the above example, both displays show that all broadcasts will
remain with the workgroup.
Use the LCM command, workgroup, to create, modify, and delete
virtual workgroups. The full syntax of the command is as follows:
workgroup [NAME [{delete | PORT-RANGE [INFO]}]]
To display all of the workgroups defined by the ELS10-26, at the
LCM prompt:
1. Type
workgroup
Summary of Contents for ELS10-26TX
