3-18
Configuring Your ELS10-26
To display information about a specific workgroup, at the LCM
prompt:
1. Type
workgroup
NAME
To create or modify a workgroup, at the LCM prompt:
1. Type
workgroup NAME PORT-RANGE INFO
To delete a workgroup, at the LCM prompt:
1. Type
workgroup NAME delete
To create or modify the port list for a specific workgroup, at the
LCM prompt:
1. Type
workgroup NAME PORT-RANGE
To display the network classification of a specific workgroup, at
the LCM prompt:
1. Type
workgroup NAME INFO
3.12 ASSIGNING A COMMUNITY NAME
A community name is similar to a password. You use the same
steps to assign a new community name or to change an existing
community name. You can then enter a community name to
perform any
SNMP
sets. The default password is public the first time
you access the device.
To assign a community name, at the LCM prompt:
1. Type
community
2. Enter the old community name.
3. If one has not been assigned,
public
is the default name.
4. Enter the new community name.
Summary of Contents for ELS10-26TX
