4-10
Monitoring and Managing Your ELS10-26
4.5.1 Disabling a Port
There can be times when you need to disable a specific Ethernet
port, for example, after you have determined that there is faulty
equipment. Disabling a port effectively stops all bridging functions
for that port. Disabled ports do not accept SNMP packets, and
therefore cannot communicate with an NMS.
To disable a port, or port range, at the LCM prompt:
1. Type
disable <PORT-RANGE>
For example,
disable 7-9
would disable ports 7, 8, and 9.
LCM responds:
Once an Ethernet port is disabled, it will be disabled until you
enable it again. Resetting the ELS10-26 will not enable a port that
has been disabled.
4.5.2 Enabling a Port
When you enable an Ethernet port that has been disabled,
whatever bridging functions you had previously configured for
that port are re-enabled.
To enable a port, or a range of ports, at the LCM prompt:
1. Type
enable <PORT-RANGE>
Caution:
If you disable the port through which someone is remotely
managing the ELS10-26, that person will not be able to
communicate with the ELS10-26. Use the LCM command
addresses display
to find the port number you are using
to manage the ELS10-26.
Port 7: Disabled
Port 8: Disabled
Port 9: Disabled
Summary of Contents for ELS10-26TX
