– 2 –
Setting Up and Powering Up the
ELS100-16TX
Setting up and powering up your ELS100-16TX is a simple
process that requires you to:
•
attach the power cord and connect to a power source
•
check power-up diagnostics sequence
Attaching Power Cord and Connecting to a Power
Source
A power cord is provided with the ELS100-16TX. Attach the power
cord to the power cord connector on the back of the
ELS100-16TX.
The ELS100-16TX is not equipped with an on/off switch. To power-
up the unit, connect the power cord to a 120 VAC or 240 VAC
single-phase stress grounded outlet.
Checking the Power-up Diagnostics Sequence
Before connecting any devices to the ELS100-16TX, power on the
unit and observe the power-up diagnostics sequence to check for
proper operation.
To observe the power-up diagnostics sequence completely, you
may want to repeat it. To restart the power-up sequence press the
reset switch on the front panel.
When you power up the ELS100-16TX, the following occurs:
1. The Power (Pwr) LED is on.
2. The CPU LED starts flashing. Two of the Port Status Mode
LEDs are on.
THIS DEVICE COMLPIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTEFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
ELS100-16
LISTED
16EO
ITE MULTIPORT
SWITCH UNIT
LINE:
100-125V~1.0A
200-240V~0.5A
50/60Hz
UL
®
UL
®
C
TUV Rheinland
gaprOfte
Sicherheit
SN
NET.
ADD.
PWR
CPU
RESET
COM
PORT STATUS MODE
TX
ACT
FDX MON
RX COL
100 USR
STATUS
ELS100-16TX
EPIM100
EPIM100
10X 12X 14X 16X
9X 11X 13X 15X
2X 4X 6X 8x
1X 3X 5X 7X
LINK
STATUS
LINK
STATUS
2
4
6
8
10 12 14 16
1
3
5
7
9 11 13 15
Reset Switch