INSTALLING THE TPT
3-4
To set the SQE switch:
•
To turn the SQE test function off, slide the SQE switch
toward the RJ-45 port. This should align the switch
with the off position (
°
).
•
To turn on the SQE test function, slide the SQE Switch
toward the AUI port. This aligns the switch with the on
position (•), as indicated on the front of the TPT.
3.3.2
Connecting the TPT to an
Ethernet Device
The TPT connects directly to an Ethernet device through
an AUI connection. You can either connect the TPT
directly to the device or use an AUI cable. If there is a slide
lock on the female connector, slide it to secure the
connector to the lock posts on the TPT’s AUI port.
Once connected, the LANVIEW PWR LED should be lit,
indicating that the transceiver is receiving power from the
device. If the SQE Test function is turned on, then the SQE
LED should also be lit.
Summary of Contents for TPT
Page 2: ......
