1
2018 DOUBLE AGENT USER MANUAL
PACKED WITH DOUBLE AGENT BOARD
(3x) Ultralight straps (non-adjustable)
(6x) Washers
(6x) M6x16 316 Stainless screws
(2x) 50mm TT fins
(2x) 30mm fins
(8x) M6x20mm 5mm Hex Screw
(10x) 6mm hole plugs
(6x) 8mm hole plugs
(1x) Sticker pack
TOOLS NEEDED:
PH3 Screwdriver & 5mm Hex Key
NOTE:
Do not use power tools to assemble your board. You will
run the risk of cross threading the inserts. Doing so will void your
warranty.
BEFORE GETTING STARTED
:
Remove all contents from the accessory package. Identify each item
from the inventory list above.
Check each insert in the board and fins by carefully threading a
screw into each to be sure it threads easily and the threads are clear
of any debris.
MOUNTING STRAPS
1. Identify the correct orientation of each strap. The Cabrinha
Ultralight Straps are designed to have the wider section of
the strap facing out toward the tip and tail of the board. This
orientation can be adjusted to fit loose so as to allow easier
twisting of either foot while offering maximum comfort and
performance. Those who desire a tighter, more locked in feel
may prefer the wider portion of the strap over the inside of the
foot instead.
2. Place the footstrap washer on the ends of the straps under the
cover.
3. Thread one of the mounting screws into the anti-twist.
4. Screw the strap into place on the board in the desired location
making sure the screw is tight.
5. Repeat this process for the other side, then for the other strap
accordingly.
CAUTION: DO NOT OVER TIGHTEN THE SCREW AS THIS WILL
DAMAGE THE INSERTS OR THE STRAPS
BOARD AND ACCESSORIES INSTALLATION
