15
9. When the laser signal is once again detected by
the Sensor, the LED turns steady green and is ready for
the next shot when an object passes through the laser.
7.2.2 Multi Shot
LV5 triggers the camera to take multiple shots when laser
signal is intercepted.
1. Follow steps in Section 7.1.
2. Set the Sensor to
Multi Shot.
3.
Set the camera’s drive mode to burst/continuous/high
speed mode
(refer to your camera user manual for
corresponding function key).
6. Aim the Emitter laser at the Sensor. When the laser is
detected, the blinking LED turns to a steady green and
the LV5 is ready to use. If the laser is never detected,
the LED continues to blink green every 3 seconds. Aim
again until the LED turns steady green.
7. Press the Test Button on the Sensor to confirm the
shutter cable or wireless connection with your camera.
At half-press, LED turns orange and camera will auto
focus; at full-press LED turns green, shutter
releases and the camera takes a shot.
8. When an object passes through the laser, the LV5
triggers the shutter of your camera and takes a shot
(delay may occur depending on camera model and lens
focusing speed).
Summary of Contents for Laser Trigger LV5
Page 1: ...User Manual Laser Trigger LV5...
Page 2: ......
Page 39: ......
Page 40: ...www cactus image com...
