20
9. Wireless Flash: Master
and Slave Modes
With a built-in Radio Frequency (RF)
module, the RF60 has the ability to
communicate with other RF60 units
wirelessly. To control and fire the
RF60 wirelessly, set up one RF60 in
Master mode and the other RF60 units
in Slave mode.
Setting up the RF60 Slave
1. Make sure that the RF60 units
that you want to control through
the Master flash are set to
mode
(see Section 7.6).
2. Set the units to the
same RF
channel
(see Section 7.7).
3. Assign RF60 Slave units to either
group A, B, C, or D. Press
to select the group for each RF60.
Each press of the Group button in
Slave mode will change the group
in the sequence of A-B-C-D. The
selected group will be shown on
the group panel.
9.1
