3
6
Operating Instructions
• Insert new high-quality alkaline AA batteries into your transmitter,
observing proper direction.
• Power up the receiver and transmitter.
• Scan-Link
TM
your system by pressing the Set/Scan button on the
receiver to automatically select operating channel.
• While the receiver display is flashing hold the transmitter
IR node in alignment with the receiver IR node within a distance
of approximately 12". The receiver will automatically set the
transmitter channel. When the display stops flashing the system
is “Scan-Link’d.”
• To set up additional units continue the sequence while keeping
previously linked transmitters away from the receiver that is
attempting to Scan-Link
TM
.
Receiver RX1600 (Front)
• Set/Scan button – Scan-Link
TM
operation
• IR Node – Scan-Link
TM
communication
• Antenna A and antenna B
• AF Peak indicator LED
• Channel display
• Diversity indicator LED
• Select button – manual selection of receiver channel
Bodypack TX1610 Transmitter
• IR Node for Scan-Link
TM
operation
• 4 pin connector (TB4M-type)
• 3 Color LED indicator
-
Green
= Transmitter is powered up
and audio is live
-
Orange
= Transmitter is powered up
and audio is muted
-
Flashing Red
= Low battery status
(change
battery
ASAP)
• Power Switch – Soft touch switch
- Holding the switch for 2 seconds turns
the transmitter on/off
- Quick momentary press of the switch
mutes or unmutes the audio
• Volume control
Specifications TX1610
Frequency Response ................................................................40Hz – 15KHz
Maximum Input Level
Microphone Input: ................................................................. -10dBV
Instrument Input: ..................................................................+15dBV
RF Output ............................................................................................. 10mW
Dimensions .............................................. 2-9/16" [6.5cm] x 4 -1/4" [10.8cm]
x 15/16" [2.3cm]
Net Weight .................................................................................... 2.8oz [82g]
Power Requirements ............................................................ 2x AA batteries
Battery Life ...................................... >15hrs, high- quality alkaline batteries
Interfacing to TX1610 input connector
3k3
3k3
3k3
3k3
3-wire type electret mic
Dynamic mic
2-wire type electret mic
Instrument
