background image

4

5

Receiver RX1600 (Rear)

 

•  1/4" unbalanced output

 

•  Volume control

 

•  Squelch adjustment  

 

  (factory preset – do not adjust without factory support )

 

•  XLR-type balanced output

 

•  DC power jack  (use included power supply)

Specifications WX1600

Maximum Output Level

  Balanced Output ................................................................................-3dBV

  Unbalanced Output ............................................................................0dBV

Output Impedance

  Balanced Output .......................................................................... 350ohms

  Unbalanced Output ..................................................................... 250ohms

Switchable Channels ................................................................................100

Dimensions .............................................. 9 -1/2" [23.0cm] x 4 -1/2" [11.4cm]

   

x 1-9/16" [4.0cm]

Weight ........................................................................................12.3oz [350g]

Power requirements .................................................... 12-15VDC, =<500mA

Handheld TX1600 Transmitter

 

•  Power Switch – Soft touch switch

 

   

-  Holding the switch for 2 seconds turns the transmitter  

 

   

  on or off

 

   

-  Quick momentary press of the switch mutes or unmutes 

      the 

audio

 

•  Tri-color LED indicator

  

 - 

Green

 = transmitter is powered up and audio is live

  

 - 

Orange

 = transmitter is powered up and audio is muted

  

 - 

Flashing Red

 = low battery status (change battery ASAP)

 

•  IR node for Scan-Link

TM

 operation

Specifications TX1600

Microphone Operating Principal ............................... Moving coil dynamic

Polar Pattern ..................................................................................... Cardioid

Frequency Response ............................................................... 40Hz – 15KHz

Maximum SPL ...................................................................................... 130dB

Dynamic Range .....................................................................................110dB

RF Output ............................................................................................. 10mW

Dimensions ................................................ 9-1/2" [24.1cm] x 1-7/8" [4.8cm]

Net Weight ...................................................................................7.3oz [208g]

Power requirements ............................................................. 2x AA batteries

Battery Life ...................................... >15hrs, high-quality alkaline batteries

5

Soft-touch power 

switch

Tri-color LED 

indicator

IR node for  

Scan-Link

TM 

operation

Summary of Contents for StagePass WX1600

Page 1: ...s device complies with Industry Canada licence exempt RSS standard s Operation is subject to the following two conditions 1 this device may not cause interference and 2 this device must accept any interference including interference that may cause undesired operation of the device Under Industry Canada regulations this radio transmitter may only operate using an antenna of a type and maximum or le...

Page 2: ...ation to minimize multipath interference Scan LinkTM technology for instantaneous scan of the RF environment and automatic link to the transmitter First the receiver conducts an environmental frequency evaluation then selects a channel Second the receiver links to the transmitter and sets the transmit frequency automatically CADLockTM AutomaticTone Encoded Squelch to eliminate unauthorized interfe...

Page 3: ...tenna A and antenna B AF Peak indicator LED Channel display Diversity indicator LED Select button manual selection of receiver channel BodypackTX1610Transmitter IR Node for Scan LinkTM operation 4 pin connector TB4M type 3 Color LED indicator Green Transmitter is powered up and audio is live Orange Transmitter is powered up and audio is muted Flashing Red Low battery status change battery ASAP Pow...

Page 4: ...lding the switch for 2 seconds turns the transmitter on or off Quick momentary press of the switch mutes or unmutes the audio Tri color LED indicator Green transmitter is powered up and audio is live Orange transmitter is powered up and audio is muted Flashing Red low battery status change battery ASAP IR node for Scan LinkTM operation SpecificationsTX1600 Microphone Operating Principal Moving coi...

Reviews: