7865 Stereo Input Channel
3-7
Revision J2005-2
J-Type
614159
+)
#
(4
#
¶4·
#
&RQWURO
The ‘Q’ control varies the bandwidth of the EQ section in the range Q=1 to Q=3. A
low value of Q gives a wide bandwidth.
This means that a relatively large range of frequencies (either side of the centre fre-
quency selected by the ‘Frequency’ control) have boost/cut applied. As the value of
Q is increased, the bandwidth is reduced, so that a very much smaller range of fre-
quencies have boost/cut applied.
61415:
+)
#
(4
#
%RRVW
2
&XW
#
DQG
#
)UHTXHQF\
#
&RQWURO
A dual-concentric potentiometer where the ‘inner’ knob is the ‘Boost/Cut’ control for
the EQ section and the ‘outer’ knob is the ‘Frequency’ potentiometer.
Boost/Cut±18 dB
FrequencyVariable from 1.5kHz to 15kHz
61415;
+0)
#
(4
#
¶4·
#
&RQWURO
The ‘Q’ control varies the bandwidth of the EQ section in the range Q=1 to Q=3. A
low value of Q gives a wide bandwidth. This means that a relatively large range of
frequencies (either side of the centre frequency selected by the ‘Frequency’ control)
have boost/cut applied. As the value of Q is increased, the bandwidth is reduced, so
that a very much smaller range of frequencies have boost/cut applied.
61415<
+0)
#
(4
#
%RRVW
2
&XW
#
DQG
#
)UHTXHQF\
#
&RQWURO
A dual-concentric potentiometer where the ‘inner’ knob is the ‘Boost/Cut’ control for
the EQ section and the ‘outer’ knob is the ‘Frequency’ potentiometer.
Boost/Cut±18 dB
FrequencyVariable from 400Hz to 4kHz
614163
/0)
#
(4
#
¶4·
#
&RQWURO
The ‘Q’ control varies the bandwidth of the EQ section in the range Q=1 to Q=3. A
low value of Q gives a wide bandwidth. This means that a relatively large range of
frequencies (either side of the centre frequency selected by the ‘Frequency’ control)
have boost/cut applied. As the value of Q is increased, the bandwidth is reduced, so
that a very much smaller range of frequencies have boost/cut applied.
614164
/0)
#
%RRVW
2
&XW
#
DQG
#
)UHTXHQF\
#
&RQWURO
A dual-concentric potentiometer where the ‘inner’ knob is the ‘Boost/Cut’ control for
the EQ section and the ‘outer’ knob is the ‘Frequency’ potentiometer.
Boost/Cut±18 dB
FrequencyVariable from 60Hz to 600Hz
614165
/)
#
(4
#
¶4·
#
&RQWURO
The ‘Q’ control varies the bandwidth of the EQ section in the range Q=1 to Q=3. A
low value of Q gives a wide bandwidth. This means that a relatively large range of
frequencies (either side of the centre frequency selected by the ‘Frequency’ control)
have boost/cut applied. As the value of Q is increased, the bandwidth is reduced, so
that a very much smaller range of frequencies have boost/cut applied.
Summary of Contents for J-Type
