7496 Dual Input Channel
3-19
Revision J2005-2
J-Type
615173
+0)
#
(4
#
%RRVW
2
&XW
#
DQG
#
)UHTXHQF\
#
&RQWURO
A dual-concentric potentiometer where the ‘inner’ knob is the ‘Boost/Cut’ control for
the EQ section and the ‘outer’ knob is the ‘Frequency’ potentiometer.
Boost/Cut±18 dB
FrequencyVariable from 400Hz to 4kHz
615174
/0)
#
(4
#
¶4·
#
&RQWURO
The ‘Q’ control varies the bandwidth of the EQ section in the range Q=1 to Q=3. A
low value of Q gives a wide bandwidth. This means that a relatively large range of
frequencies (either side of the centre frequency selected by the ‘Frequency’ control)
have boost/cut applied. As the value of Q is increased, the bandwidth is reduced, so
that a very much smaller range of frequencies have boost/cut applied.
615175
/0)
#
%RRVW
2
&XW
#
DQG
#
)UHTXHQF\
#
&RQWURO
A dual-concentric potentiometer where the ‘inner’ knob is the ‘Boost/Cut’ control for
the EQ section and the ‘outer’ knob is the ‘Frequency’ potentiometer.
Boost/Cut±18 dB
FrequencyVariable from 60Hz to 600Hz
615176
/)
#
(4
#
¶4·
#
&RQWURO
The ‘Q’ control varies the bandwidth of the EQ section in the range Q=1 to Q=3. A
low value of Q gives a wide bandwidth. This means that a relatively large range of
frequencies (either side of the centre frequency selected by the ‘Frequency’ control)
have boost/cut applied. As the value of Q is increased, the bandwidth is reduced, so
that a very much smaller range of frequencies have boost/cut applied.
615177
/)
#
%RRVW
2
&XW
#
DQG
#
)UHTXHQF\
#
&RQWURO
A dual-concentric potentiometer where the ‘inner’ knob is the ‘Boost/Cut’ control for
the EQ section and the ‘outer’ knob is the ‘Frequency’ potentiometer.
Boost/Cut±18 dB
FrequencyVariable from 20Hz to 200Hz
615178
(4
#
¶,Q
2
2XW·
Press the “EQ IN” button to put the equalizer into the channel signal chain.
615179
/3
#
)LOWHU
#
¶,Q
2
2XW·
Press the “LP IN” button to put the Low Pass Filter into the channel signal chain.
61517:
+3
#
)LOWHU
#
¶,Q
2
2XW·
Press the “HP IN” button to put the High Pass Filter into the channel signal chain.
61517;
(4
#
DQG
#
)LOWHUV
#
¶3UH·
#
RU
#
¶3RVW·
#
,QVHUW
The default routing for the EQ and Filter sections is ‘post’ the insert point.
Summary of Contents for J-Type
