3.
Assembly Instructions
4. Using the Appliance
5. Fitting and Changing the Gas Container
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
Before connecting the gas supply, firstly check that the appliance valve is in the off position by turning the knob (N) clockwise
to its stop (See Fig. 4).
Note: The hose and regulator are not supplied with the Safari Chef. For details, contact your local stockist.
The hose length should be no less than 800 mm and shall not exceed 1.5 m. Check the expiry date on the hose and
replace when necessary or when national conditions require it.
Do not twist or pinch hose.
Your appliance is now ready for use.
This Appliance must be used outdoors only!
When in use, protect from wind for optimum performance.
Do no move the appliance during use. The use of protective gloves is recommended.
Accessible parts may become very hot. Keep young children away from the appliance.
To pack away, let the unit cool. After cleaning, place the appliance in the protective Carry Bag.
Keep the appliance in the protective Carry Bag when not in use, as this will prevent the ingress of dirt or insects which may
affect the gas flow.
When attempting to light the appliance, make sure that the gas supply from the cylinder is open prior to turning on the gas
supply to the appliance.
To light the appliance, light a match or barbecue lighter, turn on the appliance gas valve by turning the valve Knob (N) in an
anti-clockwise direction to the open position and light the appliance Burner (J) (see Figs.4).
Use the control knob to adjust the flame intensity to the desired level by turning the knob clockwise to decrease the flame
and anti clockwise to increase the flame.
If flaring occurs, firstly check that the Venturi (L) is not blocked (See Fig. 6). Flaring may also occur if food with a high fat
content is cooked with the heat setting too high. In this instance, reduce the heat setting by adjusting the control knob.
When not in use disconnect the appliance from the gas supply.
Before fitting the regulator to a gas container, ensure that the seal on the regulator is in position and in good
condition. This should be done on every connection.
Ensure that the gas container is fitted or changed outdoors, away from any source of ignition, such as naked flames or
electric fires and away from other people.
Making sure that the gas container is kept upright, screw the regulator onto the gas container until it is fully engaged. Do not
over tighten.
If there is a leak on your appliance (smell of gas), take immediately into a flame-free location where the leak may be detected
and stopped. If you wish to check for leaks on your appliance, do it outside using soapy water only, which is applied to the
joints. A formation of bubbles will indicate a gas leak.
Check that all the connections are securely fitted and re-check with soapy water. If you cannot rectify the gas leak, do not use
the appliance. Contact your local CADAC stockist for assistance.
When changing a gas container close the container valve (if fitted) and then the appliance Valve (M) (see Figs.4 and 6).
Making sure the
Fit the Handles (C3) to the Dome/Wok (C1) by pushing the Handles over the Handle Brackets (C2) and fastening them
using the screws and nuts supplied. (See Fig. 2)
To open the legs, turn the unit upside-down and hold the legs down while releasing the Leg Clip (W).
WARNING: The legs are spring loaded and will spring open once the Clip has been released. Hold down the legs and
release them in a controlled manner to avoid personal injury or damage to your Safari Chef
Appliance categories: Push an 8mm inside diameter Hose onto the Valve Tailpiece (X) until it
is properly seated. On the other end attach a suitable 30mbar low-pressure ( I 3B/P (30) and I 3+ (28-30/37) Butane
configurations) or 37mBar low-pressure regulator.
( I 3+ (28-30/37) Propane configuration), again making sure that the hose is well seated. The hose used must comply
with applicable EU or regional regulations.
I 3B/P (30) and I 3+ (28-30/37)
CAUTION:
flame is extinguished, unscrew the regulator. Re-fit a full gas container following the same precautions as
described above.
