•
READY (Green light) Turns on (green) when zone 1 through 6 are good (or bypassed) and the system is ready to arm; off
otherwise.
•
INSTANT (Red light) Turns on (red) when the entry/exit zones are instant; off otherwise.
•
AC ON (Red light) Turns on (red) when the AC power is on; off otherwise.
•
FIRE (Red light) Turns on (red) when a smoke or heat detector is activated; is reset by pressing the RESET button [*]; off
otherwise.
•
TROUBLE (Red light) Turns on (red) when the Fire Zone has a technical problem; is reset by pressing the RESET button [*]; off
otherwise.
•
ZONES 1-6 (Yellow light) Turns on (yellow) solid when bypassed; blinks when faulted; off otherwise.
Understanding Your Keypad Control Tones (Beeps)
A sounder is built into the keypad and will sound for the following reasons:
•
One Beep any time any key is pressed.
•
Continuous Beep during entry delay.
•
Pulsing Beep when (a) fire TROUBLE light is lit, or (b) you arm (or disarm) your alarm when the FIRE (or fire TROUBLE light)
is lit, or (c) the “AC” power is off. To stop the pulsing, entering your code.
•
Three (3) Beeps when you try to arm your alarm with a faulted zone (ex: a door is still open; someone is moving in front of a
motion detector).
•
Single, Long Beep A one (1) second beep at the end of the exit delay (to warn you the alarm is now armed).
Clearing Malfunctions / Resetting Your Alarm System
In the event of a malfunction by your alarm, reset your system by pressing the pound button [#]; this button is in the lower left of your
keypad control panel. Hold the pound button [#] down for one (1) second. This should reset the code sequence and restore normal
operation. If this fails to solve the situation or you cannot otherwise return your system to normal, call Carolina for service help at the
numbers on the reverse side.
Chime
(NOTE: The "chime" feature is an upgrade feature which must be programmed into your system; it is not operating on most systems)
To turn your door "chime" on (or off) press the first digit of the master code. After ten seconds, a confirmation tone will activate the
chime. To deactivate the chime repeat the same step. When chime is on, your keypads will sound a "chime" each time a perimeter
zone (e.g. door) is opened.
