CADDX NetworX NX-8, User Manual

8

Step 3

•

  Press the [STAY] key.

•

 The 

stay light will illuminate indicating that all interior zones are

bypassed.  (All interior devices will bypass automatically, giving the
user freedom of movement within the interior area.)

•

 The 

bypass light will illuminate if any zone(s) are bypassed. If any

zone(s) have been bypassed previously by the user, the light(s)
corresponding to the bypassed zone(s) will illuminate, alerting the
user that a zone(s) may be unprotected and can be faulted without
an alarm.

Step 4

•

  To toggle from a “delayed entry” mode to an “Instant” mode, press

the [STAY] key again.

•

 The 

instant light will illuminate indicating that the entry/exit doors

have no entry delay.

USING THE QUICK ARM  (Optional, see page 1)

The Quick Arm feature may be used if it is enabled. Quick Arm will allow the user
to arm the security system in the AWAY mode by pressing the [EXIT] key, or arm
in the STAY mode by pressing the [STAY] key.  This feature is used for ARMING
ONLY, and will not disarm the security system.  This is ideal for a maid or baby
sitter code, etc.

CHANGING MODES WHILE SYSTEM IS ARMED

ƒ

 Pressing 

the 

[STAY] key will turn on/off (toggle) a delay on entry/exit

doors and turn on/off (toggle) the 

instant light.

ƒ

(Optional)  Press the [BYPASS] key at this time to turn on/off (toggle) all
designated interior zones.

ƒ

(Optional)  When armed, pressing the [EXIT] key will start the exit delay,
enabling you to leave the building.

IMPORTANT

The 

instant light needs to be off at this time if you plan on re-entering the

building; otherwise you will create an alarm. You may restore an entry
delay by pressing the [STAY] key again.

DISARMING THE SYSTEM

When you enter the protected area through one of the designated Entry/Exit
doors, the keypad control will sound a continuous tone for the duration of the
entry delay time, or until you enter a valid code.  The red 

armed light will go off

and the tone will stop. The security system is now DISARMED.  If a valid code is
not entered before the end of the entry delay, an alarm will occur.  (NOTE:  If the
red 

armed light is flashing during the entry delay, the alarm system has

been activated in your absence. Leave the building immediately and call
your alarm company and/or the police from a safe location.)