16
LOCATION 137: IMMEDIATE RESTORE BY ZONE
If a "1" is programmed in location 137, restoral signals will follow the restore condition and report restores immediately
after the condition has unfaulted. A non-extended format will not send a restore message until all zones and trouble
conditions have restored. If this location contains a "0", the restore signal or signals will be reported only after siren
timeout.
LOCATION 138: NO ARMING WITH A ZONE BYPASSED
If a "1" is programmed in location 138, the Ranger 8000 will not arm with any zone bypassed. If programmed with
a "0", up to 5 of the 6 burglary zones can be bypassed, and the Ranger 8000 can still be armed. If an
A
8" is
programmed, it will prevent beeping if A.C. power is lost and having to re-enter codes two times to stop the beeping.
LOCATION 139: PROGRAMMING THE QUICK ARM DIGIT
Location 139 contains the "Quick Arm" digit. To enable, program a digit (1-9) in this location. If the "Quick Arm" digit
is the same as the first digit of the Master code (user 1), the "Chime" feature will not function. The "Quick Arm" digit
cannot be the same as the first digit of the "Go To Program" code. Default is "0", disabled.
LOCATION 140: PRIORITY SIREN CUTOFF INHIBIT
If a "1" is programmed in location 140, a Priority zone type siren will sound continuously until an arm/disarm code is
entered. If this location contains a "0", the Priority zone type siren will shutdown after the amount of time programmed
in location 077 has elapsed. Programming in this location does not affect the burglary siren.
LOCATION 141: DOUBLE LINE EXTENDED ALARM REPORTING
If an extended format is selected in location 052, and a "1" is programmed in location 141, all reports will be double
line extended. If location 141 contains a "0", only non-alarm reports will be extended (restore, cancel, opening,
closing, bypass, and trouble). With this format, the central station will receive the report on two printed lines. The
example below shows a burglary report from zone 6 of account number 999. Zone 6 was programmed to report a 3.
LINE 1: 999 (ACCOUNT CODE) 3 (CODE)
LINE 2: 333 (ACCOUNT CODE) 6 (EXT CODE)
LOCATION 142: SIREN/BELL TEST FEATURE
Programming a "1" in location 142 will cause the siren/bell to come on each time the [1] and [7] keys are pressed
simultaneously. The siren/bell can be silenced with an arm/disarm code. The siren/bell test does not cause the
communicator to transmit a message.
LOCATION 143: RESETTABLE AUXILIARY POWER
Programming a "1" in location 143 will cause the 8000 (when in the disarmed state) to interrupt the smoke detector
power each time the [#] button is pressed. If this location contains a "0", the smoke detector power will reset only after
the [#] button is pressed when zone(s) designated as Priority zone types are on steady for alarm or blinking for
trouble.
LOCATION 144: EUROPEAN PULSE DIAL RATIO
Programming a "1" in location 144 will change the pulse dialing make/break ratio and interdigit spacing to conform
to most European telecom standards.
