18
Table 2.1
DATA
ACTIVATION ON
NOTES
"0"
BURGLARY ALARM
MOMENTARY OUTPUT *
"1"
FIRE ALARM
MOMENTARY OUTPUT *
"2"
PANIC ALARM / DURESS
MOMENTARY OUTPUT *
"3"
ARMED STATE
LATCHED OUTPUT
"4"
ARMED WITH BYPASS
LATCHED OUTPUT
"5"
AC POWER
LATCHED OUTPUT
"6"
LOW
BATTERY LATCHED
OUTPUT
"7"
LINE SEIZURE / LISTEN IN
MOMENTARY OUTPUT
"8"
TAMPER ALARM
LATCHED OUTPUT
"9"
AUTOTEST MOMENTARY
OUTPUT
"10"
PHONE
FAULT LATCHED
OUTPUT
"11"
ALARM MEMORY
LATCHED OUTPUT
"12"
ENTRY/KEYPAD SOUNDER **
LATCHED OUTPUT
"13"
EXIT
LATCHED OUTPUT
"14"
STATUS LED
LATCHED OUTPUT
"15"
GROUND START
MOMENTARY OUTPUT
* The Fire, Panic, Burglary options for the auxiliary outputs can be programmed for momentary, or to follow the
siren. Programming a "2" in location 132 will activate the auxiliary outputs when these events occur. Programming
a "0" in location 132 will cause the Burglary and Panic outputs to activate when the yelping siren is on and the Fire
auxiliary output to activate when the steady siren is on.
** See Location 243
LOCATIONS 149: INVERTING THE AUXILIARY OUTPUTS
Auxiliary outputs are normally "OFF", and turn "ON" when the selected condition occurs. For outputs you wish to
reverse, add up their values according to the following chart and program the sum in this location. For example, to
reverse outputs 2 and 3, program a "6" (2 + 4 = "6") in location 149.
VALUE
DESCRIPTION
1
Invert auxiliary 1 output
2
Invert auxiliary 2 output
4
Invert auxiliary 3 output
8
Invert auxiliary 4 output
LOCATION 150: AC POWER LOSS DELAY FEATURE
Location 150 contains the number of two-minute delays (two to fourteen minutes) the communicator will wait before
reporting an AC power failure. A "1" programmed in this location will create a two minute delay, and a "7" will create a
fourteen minute delay. If a "0" is programmed in this location, AC power failures will be reported immediately if AC
power loss reporting is enabled in locations 120-121. (NOTE: DO NOT PROGRAM A NUMBER HIGHER THAN "7"
IN THIS LOCATION.)
LOCATION 151: PROGRAMMING THE NUMBER OF RINGS TO ANSWER DOWNLOAD CALL
Location 151 contains the number of rings the 8600E must detect before answering the telephone when initiating a
download. If a number from "1" to "15" is programmed in this location, the control will answer after THIS number of rings
has been detected. If a "0" is programmed in this location, the 8600E will not answer the download call. Pressing the [
@
[9] [#] on the keypad while the phone is ringing will cause the control panel to answer the call immediately, if the system
is in the disarm state. (SEE LOCATION 196 or 280: ANSWERING MACHINE DEFEAT)
