25
REPORTS TO SEND TO BOTH PHONE NUMBERS
DATA FOR LOCATION 205
Maintenance Code Open/Close
"1"
Open/Close
"2"
Open/Close; Maintenance Code Open/Close
"3"
Low Battery
"4"
Low Battery; Maintenance Code Open/Close
"5"
Low Battery; Open/Close
"6"
Low Battery; Open/Close; Maintenance Code Open/Close
"7"
Ac Fail
"8"
Ac Fail; Maintenance Code Open/Close
"9"
Ac Fail; Open/Close
A = "10"
Ac Fail; Open/Close; Maintenance Code Open/Close
B = "11"
Ac Fail; Low Battery
C = "12"
Ac Fail; Low Battery; Maintenance Code Open/Close
D = "13"
Ac Fail; Low Battery; Open/Close
E = "14"
Ac Fail; Low Battery; Open/Close; Maintenance Code Open/Close
F = "15"
LOCATION 206: ALL REPORTS TO BOTH THE PRIMARY AND SECONDARY PHONE NUMBERS
Programming a "1" in location 206 will cause the 8600E to send all reports to both the primary and secondary telephone
numbers.
LOCATION 207: CALLBACK PHONE NUMBER CONTROL
The number programmed in location 207 controls the use of the callback telephone number. The callback number must
be programmed in the download section for this location to have an effect. The callback number will be used according
to the following binary scale:
VALUE
DESCRIPTION
1
Add if a callback should not occur before a download session
2
Add if [
U
] [8] [#] sight initiated download is enabled
4
Add if callback at autotest intervals is enabled
8
Add to callback when event log is full
LOCATION 208: FORMAT OVER-RIDE LOCATION
The number programmed in this location will select the available format options. NOTE: You must use DTMF
transmission for the Pager format to function (see location 209 below).
VALUE
DESCRIPTION
1
Add for Pager format
2
Add for Ademco Handshake
4
Add for Caddx modem
8 Reserved
LOCATION 209: FORMAT OVER-RIDE LOCATION
The number programmed in this location will select the available format options. NOTE: You must use DTMF
transmission for the Pager format to function.
VALUE
DESCRIPTION
1
Add for Contact ID
2
Add for SIA
4
Add for 4 + 3
8
Add for DTMF transmission
