33
APPENDIX 2 - REPORTING IN CONTACT ID
The 8600E has the ability to report Ademco Contact ID transmissions to either or both phone numbers. Each report in
Contact ID consists of an Event Code and a Zone or User ID. The zone or User ID is programmed in the first digit of each
report. When programming the event code (the second digit) for zones 1-8 (locations 105, 107, 109, 111, 113, 115, 117, or
119), programming a zero will cause the event code to follow the zone type for that zone. The event code for the zone type
can be overridden by programming a digit from the table below. Duress (location 87), AUX 1 (location 89), AUX 2 (location
91), and keypad Panic (location 93) must be programmed from the table below:
Programmed Event Code
Contact ID Code
Description
0
122
Silent Panic (for Loc. 93 only)
1 110
Fire
Alarm
2 120
Panic
alarm
3 130
Burglary
Alarm
4 131
Perimeter
Alarm
5 132
Interior
Alarm
6 133
24-hour
Burglary
7 134
Entry
Alarm
8 135
Day/Night
Alarm
9 150
Non-Burglary
24-hour
10 121
Duress
Alarm
11
100
Medical Alarm (Not used for UL)
12
123
Audible Panic Alarm
13 137
Tamper
Alarm
14 602
Periodic
Test
15
300
System Fault
The following reports will send fixed event codes regardless of the number programmed in the event code location:
Event
Contact ID Code
Event Code Location
Keypad Tamper
137
95
Download Complete
412
97
Autotest 602
99
Failed to Communicate
354
101
Closing 401
102
Opening 401
103
AC Loss
301
121
Low Battery
302
123
Trouble 380
124
Bypass 570
125
Restore *
126
Cancel 406
127
Maintenance Open
401
172
Maintenance Close
401
173
Exit Error
138
210
Recent Closing
401
211
Auxiliary 3
140
253
User on site
605
254
* This will send the event code for the zone restored.
