8
PAGES 8 & 9 DESCRIBE ALL THE LOCATIONS WHICH MUST BE PROGRAMMED FOR THE
RANGER 8980 TO FUNCTION AND REPORT TO A CENTRAL STATION. OTHER OPTIONS
MAY BE SELECTED BY FOLLOWING THE ADDITIONAL PROGRAMMING INSTRUCTIONS
LOCATIONS 032-047: PROGRAMMING THE PRIMARY TELEPHONE NUMBER
The primary telephone number is programmed in successive locations beginning with location 032. Any zero (0) within
the telephone number, must be programmed as a "10". A "0" indicates the end of the phone number. Delays of four
seconds can be programmed at any point in the phone number by programming a "13" in the appropriate location. If
tone dialing is desired, program a "15" in the location where tone dialing should begin. If the entire number should be
tone dialing, program a "15" in location 032. When using split reporting, the primary number always takes priority over
the secondary telephone number.
LOCATIONS 048-051: PROGRAMMING THE ACCOUNT CODE FOR THE PRIMARY PHONE NUMBER
The account code sent when the PRIMARY phone number is dialed is programmed in locations 048-051. Any zero (0)
within the account code must be programmed as a "10", and the communicator will report a zero (0). If the account
code is three digits long, use locations 048, 049, and 050. Program a "0" to indicate the end of the account code.
LOCATION 052: PROGRAMMING COMMUNICATOR FORMAT FOR THE PRIMARY PHONE NUMBER
Location 052 contains the communicator format used to transmit to the receiver connected to the primary phone
number. Consult the instructions for your central station receiver to determine which format is compatible. To select
Ademco/Silent Knight Fast
, program a "2" in location 052.
Sescoa/Franklin Fast
requires a "4" in this location, and
Radionics 1800HZ/2300HZ Fast with Parity and Hex Capability
requires a "9" in this location. If you need another
format, choose from those listed on the format table located on page 13 and program the data in location 052. If this
location contains a "0", the built-in communicator will be disabled, and the Ranger 8980 will function as a local only
control.
LOCATION 053: DISABLING THE SECONDARY TELEPHONE NUMBER AS A BACKUP
Location 053 is used to disable the secondary phone number as a "backup". This feature can be used with split
reporting (locations 176-177) to prevent a report from going to the secondary telephone number after unsuccessful
attempts to the primary phone number. If location 053 contains a "0", the secondary phone number will backup the
primary, and the primary phone number will backup the secondary. If location 053 contains a "1", only the primary
phone number will be called.
LOCATIONS 054-069: PROGRAMMING THE SECONDARY TELEPHONE NUMBER (SPLIT REPORTING)
Locations 054-069 contain the secondary telephone number. This number allows certain communicator reports to go
to another number (split reporting), or to cause the communicator to dial a second number if the primary number does
not respond after the number of attempts programmed into location 134 have been tried unsuccessfully. The same
number of attempts are made with the back-up number. Tone dialing and delay instructions are the same as for the
primary number.
LOCATIONS 070-073: PROGRAMMING THE ACCOUNT CODE FOR THE SECONDARY PHONE NUMBER
Locations 070-073 contain the account code for the secondary phone number. Any zero (0) within the account code
must be programmed as a "10", and the communicator will report a zero (0). If the account code is three digits long,
use locations 070, 071, and 072. Program a "0" to indicate the end of the account code. If these locations are left
blank, the account code in locations 048-051 will be reported.
