q
INSTANT/DELAY OPTION
If checked, your installing company has selected the “INSTANT” option. With this feature
enabled, if you do not wish to have a delay on your entry/exit doors, this can be accomplished
by pressing the
key on your keypad while the system is “ARMED”. At this time, the
“INSTANT” light will illuminate and there will be no entry delay when the entry/exit doors are
opened. Any time the “INSTANT” light is on and the exit delay has expired, the opening of an
entry/exit door will produce an immediate alarm, making this feature ideal when a high level
of security is desired, and no authorized entries are anticipated. By pressing the
key again.
the “INSTANT” light will turn off, and an entry delay will be present on designated entry/exit
doors.
NOTE: Your installing
may have programmed the “INSTANT” option to occur in
conjunction with the “AUTOMATIC BYPASS” feature. In this case, the “INSTANT” light and the
bypassed “ZONE” lights will become illuminated at the end of the exit delay. If this occurs, you
still have the ability to turn the “INSTANT” feature off, and/or on by pressing the
key.
ENTRY-GUARD OPTION
If checked, your installing company has selected the “ENTRY-GUARD” option. If you wish to
arm your system in a low security mode, you may do so by pressing the preset
GUARD” digit (see page 1 for the selected digit). Five seconds later, the security control will
bypass all non “ENTRY-GUARD” zones, and arm the system with all “Entry-Guard” zones
delayed. This mode of operation will allow you time to DISARM (turn off) the security system
in the event a zone is accidentally opened.
KEYPADACTIVATED PAN/C/HOLD-UPALARM
If checked, your installing company has selected this feature. If so, when the star
and
pound
keys are pressed at the same time for one second, a local audible alarm will sound.
If your system is connected to a monitoring center, an emergency report could be transmitted
to that center. These keys should only be pressed in an emergency situation requiring
immediate response by law enforcement personnel.
PLEASE NOTE: Some Panic/Hold-up alarrns are programmed to be silent at the protected site
while reporting an alarm to the monitoring center. Check with your installing company to
determine how your security system will respond to the Panic/Hold-up activation.
KEYPAD ACTIVATED FIRE ALARM
If checked,
your installing company has selected this feature. If so, you can activate the steady
siren by pressing the one
[I]
and three
keys at the same time for one second. If your
system is connected to a monitoring center, an emergency report could be sent to that center.
These keys should only be pressed in an emergency situation requiring response by fire
department personnel.
q
If checked, your installing company has selected this feature. If so, you can activate the
auxiliary alarm by pressing the four
and six
keys at the same time for one second. If your
system is connected to a monitoring center, an emergency report could be sent to that center.
These keys should only be pressed in an emergency situation requiring response by
emergency personnel. When the “4” and
are pressed together, the keypad will start to
beep until a code is entered.
