ELECTROMAGNETIC INTERFERENCE
:
It is very important that you notice and understand
this information regarding the possible effects of Electromagnetic
Interference on your remote golf trolley.
Electric remote golf trolley may be susceptible to electromagnetic
interference (EMI), which is interfering electromagnetic energy (EM)
emitted from sources such as radio stations, TV stations, amateur radio
(HAM) transmitters, two-way radios, and cellular phones. The
interference (from radio wave sources) can cause the remote golf
trolley, reduced its remote distance, move by itself, or move in
unintended directions.
It is recommended to do following when your trolley is unattended:
Always switch the power off and keep potentiometer on “0” (zero)
position (on handle grip) before leaving your trolley or while
unattended.
You can also Disconnect battery connector before leaving your
trolley.
This trolley complies with current telecommunications regulations for
conforms to CE and FCC, but we strong recommend you read this
manual completely before you start to use your trolley.
- 3 -
RELEASE AND ASSEMBLE THE WHEELS
To assemble the wheels:
Insert the wheel on the axle in the direction of the arrow.
Open the locking system B, then insert onto the axle, put slot C onto
the pin A.
Release locking system B and make sure the wheels have been
locked.
On the inside of the wheel, there is a color mark, the red dot for the
right side and blue dot on the left side.
Free wheeling:
In case of power failure, for easier to push your trolley, the wheels can
be disengaged from motor by putting the locking system on outside of
axle groove.
To release the wheels:
Open the locking system B, then pull out the wheel.
Inflate the air tire model to a maximum of 1.2 bar (18 PSI) for air tire.
- 4 -
