Pg.
2
of
2
Step 6:
Remove Bag Support Bar. Use the
2.5 mm hex wrench and loosen the set screw
inside joint(s) to remove the bag support bar.
Step 7:
Replace the defective part; bag
support bar or joint(s).
INSTALLATION
Step 8
: Align the set screw on joint to the
screw hole on bag support bar, then tighten.
Repeat for other joint. DON’T over tighten!
Step 9:
Install the Upper Joint Assembly to frame.
Use rubber mallet and gently tap into place. Align
holes, insert screws, and tighten.
Step 10:
Install Pull Handle to Upper Joint
Assembly. Use rubber mallet to gently tap into
place. Align holes, insert screws and tighten.
Step 11:
Loosen black knobs, squeeze joint
together, insert screws, then tighten. DON’T
over tighten. Repeat for the other joint.
The End:
Congratulations, you have
successfully replaced the upper joint assembly
