18
MARTINA - VANESSA - ALESSIA - SOLARIS
EN
The stove is provided with a hand rejector: this rejector can be removed exclusively by the
stove manufacturer or by the Technical Assistance Service.
During its running, the stove reaches high temperatures: keep away childreen and animals
and for your safety please use appropriate fireproof devices, such as heat-protecting gloves.
10.2
INTRODUCTION
To have the best performance with the lowest consumption please follow the here descripted instructions.
•
The lightning of the pellets occurs very easily if the installation is correct and if the chimney flue is efficient.
•
Switch on the stove at Power 1 for at least 2 hours in order to enable the materials which make up the boiler
and the fireplace to adjust the inner springing stress.
•
Oily plant waste and lacquers can cause smells and smoke during the first working hours: it is advisable to
ventilate the room because they could be noxious to people and animals.
•
By using the stove the varnish inside the combustion chamber could be subjected to alterations. This
occurrence can be attributed to different reasons: an excessive stove overheating, the presence of chemical
agents in bad quality pellets, bad chimney draught, etc. Therefore varnish endurance in the combustion
chamber cannot be guarantee.
Set values from 1 to 5 are defined by the manufacturer and they can be changed only by
an authorized technician.
Do not use flammable liquids during the ignition (alcool, petrol, oil, etc...).
10.3
CONTROL PANEL
PANEL ELEMENT
DESCRIZIONE
P1 e P2: when you are in set temperature mode the termostat values increase or
decrease from min. 6°C to max. 40°C. Keeping pressed P2 you check the fume
temperature at outlet. Both have programming functions.
P3: enable to have access to temperature set and to User and Technician parameters
menu.
P4: ignition and shut down, unblocking from probable alarms and exit from
programming.
P5 e P6: increase and decrease the calorific power from 1 to 5.
Hourly programming: acitvated.
Auger: activated.
Remote control data reception
