ATRIUM AT 5kW-ROXY-MADISON-SOLO-TABLA
20
Fig. 15 - Display: key
8.3.9 Menu M9 - PELLET TYPE
It allows you to adjust the quality of combustion and the flame based on the fuel quality or draft of the flue (see
Thanks to this adjustment the fuel supply in the burn pot may be modified by an amount between -18% and +18% (value from
-9 = -18% to +9 = +18%).
Fig. 16 - Display: pellet type
8.3.10 Menu MA - FLUE TYPE
The RPM of the flue gas extractor fan may be changed as a percentage to counter some draft issues or reduce extraction in case of
flues with excess draft (see
).
The flue gas extractor speed adjustment can vary between -18% and +18% (value from -9 = -18% to +9 = +18%).
Fig. 17 - Display: flue type
8.3.11 Menu MB - EXIT
Selecting this item by pressing button P3 (see
), exits the menu and returns to the previous state.
Fig. 18 - Display: exit
8.4
STOVE SWITCH-ON
We remind you that the first start-up must be carried out by skilled and authorised technical personnel who check that everything
is installed according to the regulations in force and verifies its functionality.
• If inside the combustion chamber there are booklets, manuals, etc. remove them.
• Check that the door is closed properly.
• Check that the plug is inserted into the socket.
• Before turning the stove on, make sure that the burn pot is clean.
Start up the stove by pressing button P3 for a few seconds so that
Turn on
"
StArt
"is displayed. In these conditions, the stove goes
into the preheating state: the spark plugs go on (visible from the spark plug LED) together with the flue gas extraction fan. Any
anomalies during the ignition phase are shown on the display and the stove goes into alarm status.
The pellet loading phase starts after about 1 minute, and the display shows the message
Pellet loading
"
LoAd PELLEt
" and the
ON/OFF LED flashes intermittently. In the first phase, the feed screw loads the pellet into the burn pot. After the temperature of
the flue gas has reached and exceeded the contained value, the system goes into ignition mode and
Fire present
"
FLAME LiGHt
" appears on the display and the ON/OFF LED flashes.
Summary of Contents for ROXY
Page 38: ...NOTE...
Page 39: ...NOTE...
