20
WALL - SMALL - STYLE
EN
•
If the feeder cable is damaged, it must be replaced by an authorized technician.
•
When the stove is not going to be used for a long period of time, it advisable to remove the plug from the
socket on the wall.
11.9
CONNECTION TO THE EXTERNAL THERMOSTAT
The stove works through a thermostat probe placed in its inner. If you desire, the stove can be connected to an
external room thermostat. This operation must be executed by an authorized technician.
•
External thermostat: "SET TEMP ROOM" a temperature which is round 7°C.
•
External chronothermostat: "SET TEMP ROOM" a temperature which is round 7°C and desable the chrono
functions from the menu 03-01 "CHRONO ENABLE" ("OFF").
11.10
VENTILATION
•
The stove is endowed with a ventilation system.
•
The air blown from fans keeps the appliance at a low temperature range in order to avoid high stresses to the
materials which make it up.
•
Do not cover the hot air outlet slits with any object to avoid stove’s overheating!
•
The stove is not suitable for food cooking.
Fig. 24 - Do not cover air slits
11.11
PARTIAL DUCTING SYSTEM
•
Removing the top finned grid and fitting a special grille shaped to allow passage of the pipes, an 80mm pipe
can be fitted to the hot air outlet, so that some of the air can be released into another small room.
•
If necessary, fit a small extractor to the pipe outlet to increase the amount of hot air released into the room.
We recommend to not use more than 1,5 meters of pipe, otherwise the hot air will lose its
effectiveness.
11.12
FUNNEL CANALIZATION MOUNTING
Proceed as follows:
Fig. 25 - Phase 1
Fig. 26 - Phase 2
Fig. 27 - Phase 3
