background image

OPERATING YOUR THERMOSTAT

Warranty

The heater and thermostat must be properly installed before they are used.

For more effective and safer operation and to prolong the life of 

the heater, read the Owner’s Guide and follow the maintenance 

instructions. Failure to properly maintain the heater will void any 

warranty and may cause the heater to function improperly. War-

ranties are non transferable and apply to original consumer only. 

Warranty terms are set out below.

LIMITED ONE-YEAR WARRANTY: 

Cadet will repair or replace 

any Baseboard (BTF) thermostat found to be defective within one 

year after the date of purchase.

These warranties do not apply:

1. Damage occurs to the product through improper installation or 

incorrect supply voltage;

2. Damage occurs to the product through improper maintenance, 

misuse, abuse, accident, or alteration;

3. The product is serviced by anyone other than Cadet;

4. If the date of manufacture of the product cannot be deter-

mined;

5. If the product is damaged during shipping through no fault of 

Cadet.

6. CADET’S WARRANTY IS LIMITED TO REPAIR OR RE-

PLACEMENT AS SET OUT HEREIN. CADET SHALL NOT BE 

LIABLE FOR DAMAGES SUCH AS PROPERTY DAMAGE OR 

FOR CONSEQUENTIAL DAMAGES AND/OR INCIDENTAL EX-

PENSES RESULTING FROM BREACH OF THESE WRITTEN 

WARRANTIES OR ANY EXPRESS OR IMPLIED WARRANTY.

7. IN THE EVENT CADET ELECTS TO REPLACE ANY PART 

OF YOUR CADET PRODUCT, THE REPLACEMENT PARTS 

ARE SUBJECT TO THE SAME WARRANTIES AS THE PROD-

UCT. THE INSTALLATION OF REPLACEMENT PARTS DOES 

NOT MODIFY OR EXTEND THE UNDERLYING WARRANTIES. 

REPLACEMENT OR REPAIR OF ANY CADET PRODUCT OR 

PART DOES NOT CREATE ANY NEW WARRANTIES.

8. These warranties give you specific legal rights, and you may 

also have other rights which vary from state to state. Cadet nei-

ther assumes, nor authorizes anyone to assume for it, any other 

obligation or liability in connection with its products other than as 

set out herein.
If you believe your Cadet product is defective, please contact 

Cadet Manufacturing Co. at 360-693-2505, during the warranty 

period, for instructions on how to have the repair or replacement 

processed. Warranty claims made after the warranty period has 

expired will be denied. Products returned without authorization 

will be refused.

Parts and Service

Visit cadetheat.com/parts-service for information on where to 

obtain parts and service.

Reduce-Reuse-Recycle

This product is made primarily of recyclable materials. 

You can reduce your carbon footprint by recycling this 

product at the end of its useful life. Contact your local 

recycling support center for further recycling instruc-

tions.

STEP 7

Turn the power back on at the circuit 
breaker or fuse box.

STEP 8A

Turn the thermostat knob fully clockwise. 
When the room reaches comfort level, turn 
the knob counterclockwise until a slight 
click is heard. The heater will now cycle 
around this preset temperature.

STEP 8B

Tamper Proof Models

Remove plastic plug and adjust the 
thermostat shaft to desired setting using a 
screwdriver. Replace the plastic plug. The 
heater will now cycle around this preset 
temperature.

©2014 Cadet     Printed in USA     Rev 09/14     #720107

Page 4

Summary of Contents for BTF1









Reviews: