Adding Equipment to Your
Airbag-Equipped Vehicle
Q:
Is there anything I might add to the front
or sides of the vehicle that could keep the
airbags from working properly?
A:
Yes. If you add things that change your
vehicle’s frame, bumper system, front
end or side sheet metal or height, they may
keep the airbag system from working properly.
Also, the airbag system may not work
properly if you relocate any of the airbag
sensors. If you have any questions about this,
you should contact Customer Assistance
before you modify your vehicle. The phone
numbers and addresses for Customer
Assistance are in Step Two of the Customer
Satisfaction Procedure in this manual.
See
Customer Satisfaction Procedure on
page 482
.
Q:
Because I have a disability, I have to get
my vehicle modified. How can I find out
whether this will affect my airbag system?
A:
Changing or moving any parts of the
front seats, safety belts, the airbag sensing
and diagnostic module, the inside rearview
mirror, steering wheel, ceiling headliner, ceiling
and pillar garnish trim, or airbag wiring can
affect the operation of the airbag system.
If you have questions, call Customer
Assistance. The phone numbers and
addresses for Customer Assistance are in
Step Two of the Customer Satisfaction
Procedure in this manual. See
Customer
Satisfaction Procedure on page 482
.
85
Summary of Contents for 2007 CTS
